product overview

Introduction

We extend a warm welcome from all of us at FMI PRODUCTS, LLC, proud manufacturers of the Grand Meridian Fireplaces. Thank you for choosing FMI.

You may have thought long and hard before you chose the fireplace which would grace your home. Rest assured that every component of the Fireplace has been tested to ensure long-term durability.

Product Overview

The Grand Meridian Fireplaces are designed as factory-built blocks to be assembled on-site. These fireplaces may be installed on either combustible or non-combustible floors. In order for the fireplace to be installed on a combustible floor though, it is necessary that the fireplace be supported on a platform or sub-floor that is non-combustible.

The Four Components of the Grand Meridian Fireplace:

•Combustible or Non-Combustible Floor

•Non-Combustible Raised Platform

•Firebox and Smoke Dome

•FMI PRODUCTS, LLC chimney system required.

Important: Follow the chimney pipe manufacturer’s instructions on the installation of their specific flue system.

Careful step-by-step instructions for each phase of the installation procedure will be given for the Grand Meridian conventional radiant heat fireplaces. Those instructions generally fall into the following categories:

•Spacing and clearance as it relates to combustible materials.

•Familiarity of installation for all components.

•The strength of the floor on which it rests.

•Chimney system measurements.

•Choice of materials and craftsmanship in fireplace and hearth finishing.

Internal

Wall

InstallationCorner

Installation

Flush

FullInstallation

Projection

Installation

Figure 4: Typical Installations

Note that each of these topics will be covered in detail and that the installer is expected to understand each phase completely before going on to subsequent instructions.

Attention: Be advised that all the illustrations in this manual are for general reference only. Do not scale drawings. Actual design elements will vary from case to case. Pay attention to specified minimum clearances to combustibles.

Testing and listing for these Grand Meridian Fireplaces has been undertaken by the PFS Corporation.

Attention: You may need a residential building permit to install a Grand Meridian Fireplace. Consult local jurisdictions before you get started!

If asked, advise the local authorities that the FMI Fireplace is designed for installation per the National Fire Protection Association Standard for Chimneys, Fireplaces, Vents and Solid Fuel-Burning Appliances (NFPA211).

When choosing the location of your FMI Fireplace, keep in mind you must maintain 2" minimum clearance from left, right and rear of Fireplace to surrounding structure. Also, when choosing a location, consider outside air requirements to determine if it will be on the left or right side of the Fireplace. In the case of an island installation, outside air accessibility may be obtained through sub flooring, see Optional Outside Air Kit on page 12.

6

www.fmiproducts.com

125160-01A