lc &care
Care and Cleaning
Marinating
with your FoodSaver® Appliance
marinate
eaning
To Clean Appliance:
Press Power Button and remove Power Cord from electrical outlet. Do not immerse in liquid.
Open Appliance Door (K), while holding the appliance with two hands, press two Release Buttons (J) with your thumbs, rotate appliance away from you, and allow appliance to rest on the counter. After cleaning, hold appliance with two hands and rotate upright until the latches lock.
Check Lower Gasket (L) around Drip Tray (N) and Upper Foam Gasket (P) which surrounds the Upper Bag Detection Tray (O) to make sure they are free from food materials. Do not attempt to remove gaskets.
Push In 
Tabs
Remove
Upper Bag
Detection Tray
& Lower Drip Tray.
Push In
Tabs
Your FoodSaver® Vacuum Sealing System has a special Quick Marinate Cycle which will last about ten minutes. The FoodSaver® Quick Marinating Canister is the perfect FoodSaver® accessory for marinating foods.
During the Marinate Cycle, the vacuum pump will “hold” the vacuum for several minutes then release the vacuum, allowing the food to “rest” for 30 seconds. This process then repeats. This “pulsing” action of “vacuuming and resting” will allow for quicker more flavorful marinating.
Important Note: Use the FoodSaver® during the Quick Marinate Cycle, make sure knob on lid of the Quick Marinating Canister accessory is
set to OPEN. Do not set knob to Vacuum during the Marinate Cycle.
F
how to
Antibacterial Drip Tray & Upper Bag Detection Tray:
Empty Drip Tray after each use. Wash in warm soapy water or place in top rack of dishwasher. The Food Sensors in the Drip Tray (N) will not function correctly if liquid is allowed to remain in Drip Tray.
This appliance has a Tray Full indicator 2 . When excess liquid fills the Drip Tray, the unit will turn off and the Tray Full Indicator light will activate. To resume normal operation, open Appliance Door (K), press two release buttons (J), rotate appliance away from you, and allow appliance to rest on the counter. Press tabs and lift to remove the Drip Tray, empty liquid, clean Drip Tray and place back into appliance. When replacing drip tray, set the right end of the drip tray into place, then firmly snap both sides down. Appliance can be used without Drip Tray, however the Adjustable Food Sensor setting 9 will not function without the Drip Tray.
Clean Upper Bag Detection Tray after each use. The Upper Bag Detection Tray (O) is removable for cleaning, remove by lifting the tabs on each end. Do not pull on the Upper Bag Detection Flags to remove the Upper Bag Detection Tray. Clean Upper Bag Detection Tray by washing in warm soapy water or placing in top rack of dishwasher. Upper Bag Detection Tray MUST be inserted to use the appliance. Without the Upper Bag Detection Tray, your FoodSaver® Appliance will not detect bag when inserted in the Vacuum Channel (E).
Remove All Food 
Around Gaskets
DO NOT
REMOVE
GASKETS
Replace
Upper Bag
Detection Tray
& Lower Drip Tray.
Rotate top to close, shut appliance door
1.Prepare enough of your favorite marinade to fully cover food inside a marinating canister.
Always leave at least one inch (2.54 centimeters) of space between contents and top of rim.
2.Make sure rubber gasket underneath lids as well as rim of marinating canister is free from food materials.
3.Make sure Retractable Accessory Hose (D) is securely inserted into port on the FoodSaver® Quick Marinating Canister lid (Fig. 1).
4.Make sure knob on accessory lid is set to OPEN (Fig. 2).
5.Make sure lid is firmly attached to marinator base.
6.Press Marinate button 5 on the control panel (Fig. 3).
7.Your FoodSaver® Vacuum Sealing System will now begin the Quick Marinate Cycle. The Marinate Indicator Light will flash to indicate the marinating process has begun.
8.During the initial vacuum cycle the Marinate Mode Indicator will illuminate. While Marinating, the Vacuum Progress Display will blink during the Vacuum Hold or Rest Cycle.
9.To preserve food safely, after completing the marinating cycle, the appliance will signal with short beeps to indicate your Quick Marinate Cycle is completed. Press any button to silence the signal. You may now cook or refrigerate your marinated food.
10.To use the Quick Marinating Canister to for extended vacuum storage (beyond the short Marinate Cycle): Rotate knob to Vacuum/Canister position, connect the Accessory hose (as above) and select the Accessory Mode cycle from the control panel. When motor turns off, rotate knob clockwise to the “Closed” position, then gently twist and remove Accessory Hose from accessory.
Fig. 1
F
Fig. 2
Fig. 3
ACCESSORY MARINATE
5
| www.foodsaver.com | www.foodsaver.com |
