Fostex VF80EX owner manual Setting effects, Effect type setting, Effect send level setting

Basic Recording/Playback (VF80EX)

4Highlight the“Lo Gain”field by using the [CURSOR ] key, and edit the “Lo Gain” value using the [JOG] dial.

You can set the value between -18 dB and + 18 dB, as same as the Hi Gain.

5Repeat steps 2 through 4 to edit EQ on other tracks.

6After completing the EQ setting, press the [EXIT/NO] key.

The LCD returns to the Normal screen.

3Use the [JOG] dial to enter the send level.

While the send level changes, the corresponding icon also changes in real time.

When the value increases, the effect sound of the cur- rently selected effect type will be output.

4To set the effect send levels for other tracks, carry out step 2 and 3 above repeatedly.

Setting effects

There are two methods for using the internal effect processor of the VF80EX: “loop effect” and “insert effect” . The following describes how to set the send level and select an effect type of the loop effect.

See “Mixer Function” for details about the loop effect, such as how to make pre/post setting of an effect send or how to set effect parameters.

See also “Advanced Operations” on page 83 for details about the insert effect.

1Press the [EFFECT] key.

The effect send level setting screen appears initially. Each press of the [EFFECT] key switches between the effect send level setting screen, effect type selection screen and effect send pre/post selection screen.

TRACK	MIX PARAMETER
EDIT	SCENE	SCENE SEQ.
PGM	FADER	MAP
PAN	EQ	EFFECT
		[EFFECT] key
		ON/OFF
	2TRK MODE
BOUNCE	MASTERING	TRAINING
REC EFF

Effect type setting

The VF80EX provides 38 effect types (L01 through L38) used for the loop effect and 6 effect types (L39 through L44) used for the insert effect.

2Bring up the effect type setting screen and select the desired effect type by rotating the [JOG] dial.

While rotating the [JOG] dial, the effect type appears one after the other among 38 types (L01 ~ L38).

Highlighted

<Note>

If you select an effect type used for the insert effect (i.e. any one of L39 through L44), the screens for effect type selection and effect send pre/post selec- tion are not shown.

3After selecting the desired effect type, press the [EN- TER/YES] key.

The selected effect type is set.

	4	Press the [EFFECT] key to bring up the effect send level
Flashing		setting screen.

5 Adjust the effect send levels as described above.

Effect send level setting

2While the effect send level setting screen is shown, press the [TRACK STATUS/TRACK SEL] key of the

desired track.

The effect knob icon of the selected track is highlighted, showing that it can be edited. The default value for track sends 1 through 6 is “0” while the default value for the master is “80” .

<Pre/post setting of effect sends>

All the effect sends from tracks 1 through 6 are initially set to “post-fader” . Therefore, when a track fader is completely down, no signal is sent even if you raise the effect send level of the track.

You can also select “pre-fader”if necessary. See “Mixer functions” for details.

<Parameter setting for each effect type>

You can set parameters for the selected effect type. See “Mixer functions” for details about parameter setting.

highlighted

<On/Off setting of the effect>

You can switch on or off the effect alternately by pressing the [EFFECT/ON/OFF] key while holding down the [SHIFT] key.

See “Mixer functions” for details.

37