Foundry Networks AR SERIES manual Management Interface, Alarms, Power, Initial Configuration

Installing and Configuring Rack-Mounted Systems

Alarms

Connect the stripped ends of two 18-22 AWG wires to alarm terminals 6 and 7 on the back-panel terminal block.

AC Receptacle

					100-240V , 2.5A, 50-60Hz				CAUTION: TO PROTECT
									AGAINST RISK OF FIRE,
	5 - 7 in-lbs					1	- 48B RTN		REPLACE WITH THE SAME TYPE
									AND RATING OF FUSE ONLY.
	0.57 - 0.79 N-m					2	- 48B
	TORQUE					3	- 48A RTN	AUX. PORT
FUSE: T3A, 250V SLOW BLOW						4	- 48A	CAUTION: TO PROTECT	AGAINST
						5	-
SEE PRODUCT MANUAL		1	2 3 4	5 6 7		6	- ALARM CONTACT	RISK OF ELECTRICAL	SHOCK,
								DISCONNECT BOTH AC	POWER CORD
						7	- ALARM COMMON
FOR CENTRALIZED DC POWER, INSTALL ONLY IN RESTRICTED ACCESS AREAS			40 - 60V	, 3.0A				AND DC WIRING BEFORE	SERVICING.

ESD

GND SUMMARY

POWER

Alarm Terminals

Power

Foundry systems operate on AC, single DC, and dual DC power. For AC power operation, connect the female end of the supplied AC power cord to the AC power receptacle on the system back panel. Connect the male end of the AC cord to a standard 110/120 VAC source. Refer to the figure above. Refer to the Installation Guide: Domestic Products for information about dual AC power connection.

To operate with single-source DC power, connect the stripped ends of two 18-AWG wires to either the A or B terminals on the terminal block. Make sure to connect the +48V lead to the appropriate RTN connector.

CAUTION: To avoid equipment damage, make sure that the +48V lead is connected to the appropriate RTN connector (either 1 or 3) on the terminal block.

To operate with dual-source DC power, connect the stripped ends of four 18-AWG wires to the both the A and B terminals on the terminal block. Make sure to connect the +48V leads to the appropriate RTN connectors.

Management Interface

To access the command line interface (CLI) via the front-panel console port, connect a terminal or a workstation running a terminal emulation software to the Foundry system. The software should be configured as follows:

•9600 bps

•8 data bits

•1 stop bit

•No parity

•XON/XOFF flow control

To remotely access the system, configure the modem data port as specified above for terminal emulation software. It is also possible to telnet to the Foundry system once an IP address is assigned to an Ethernet port.

Initial Configuration

Use the following commands to log in as the system administrator, choose a host name, change the password, set the system time, and enter an Ethernet IP address.

June 2004 © 2004 Foundry Networks, Inc. 2 - 5