Installing Batteries

 

Installing Book Cards

Your BOOKMAN is powered by two AAA, 1.5-volt batteries. Follow these easy instructions to install or replace them.

1.Turn your BOOKMAN® over.

2.Lift the battery cover on the back of your BOOKMAN by pushing it in the direction of the arrow.

3.Install the batteries as shown on the diagram in the battery compartment.

4.Replace the battery cover.

Warning: If the batteries wear-out completely, or if you take more than approximately a minute while changing the batteries, any information that was entered in the built-in book or book card will be erased. You should always keep written copies of your important information.

Resuming Where You Left Off

You can turn off your BOOKMAN at any screen. When you turn it on again, the last screen you viewed appears.

1.Turn your BOOKMAN off.

2.Turn your BOOKMAN over.

3.Align the tabs on the book card with the notches in the slot.

4.Press the book card down until it snaps into place.

Removing Book Cards

Warning: Never install or remove a book card while your BOOKMAN is on. Any information that was entered in the built-in book or book card will be erased.

32

Page 7
Image 7
Franklin None manual Installing Batteries Installing Book Cards