The ice cube machine begins with a fixed charge of water that is contained in the water tank. As the water flows to the freezing evaporator surface, the water will freeze and stick to the ice cube molds. During the
Evaporator |
| |
Water |
| |
inlet |
| |
| Water | |
| pump | |
Water | Hot gas valve | |
tray (trough) |
| |
| Compressor | |
Condenser | Fan | |
motor | ||
|
Normal Sounds
Your new ice cube machine may make sounds that are unfamiliar to you. Most of the new sounds are normal. Hard surfaces like the floor and walls can amplify the sounds. The following describes the kinds of sounds that might be new to you and what may be causing them.
•Rattling noises may come from the flow of the refrigerant or the water line. Items stored on top of the ice cube machine can also make noises.
•The
•Running water may make a splashing sound.
•You may hear air being forced over the condenser by the condenser fan.
•During the Harvest cycle, you may hear the sound of ice cubes falling into the ice storage bin.
Preparing the Ice Cube Machine for Long Storage
If the ice cube machine will not be used for a long time, or it is to be moved to another place, it will be necessary to drain the system of water.
1.Shut off the water supply at the main water source.
2.Disconnect the water supply line from the water inlet.
3.Shut off the power supply at the main electrical power source.
4.Screw off the water tank screw nut and drain out water completely, then tighten the nut after finishing. Dry the tank.
5.Take out the ice storage bin to remove ice. (See pp.
6.Leave the door open to allow for circulation and to prevent mold and mildew.
7.Leave the water supply line and power cord disconnected until ready to reuse.
IMPORTANT:
¥Do not touch the power plug when your hands are wet.
¥Never unplug the unit by pulling on the cord.
Cleaning and Maintenance
13
