Franklin Industries, L.L.C FIM200 user manual Operation, Installation Types

remove the nut.

4.Connect nuts of the water supply hose to tap and water inlet valve. Tighten firmly by hand, then one-half turn with wrench.

5.Turn on main water supply and tap. Check for water supply connection leaks. Tighten every connection (including connections at the water inlet).

Installation Types

This ice cube machine has been designed to be enclosed (as under a cabinet). It can also be free-standing (using the supplied stability brackets) or built-in (sealed to the floor). In every case, there must be adequate air space around the unit for ventilation purposes (see diagrams on page 8).

Enclosed Installation:

An enclosed installation will allow you to install the ice cube machine under a counter or in a kitchen cabinet provided the required clearance space around the ice maker is respected. You must follow the stated instructions for

a. Electrical requirements b. Water supply

Free-standing Installation:

The ice cube machine can be installed to be free-standing in any place you desire provided you have access to a water supply. This installation has the same requirements as an enclosed installation, plus you must also follow the stated instructions for Installing the Stability Brackets.

Built-in Installation:

If this method of installation is chosen, it will still be necessary to allow adequate ventilation space around the unit. The following additional items must be observed.

1.Place the ice cube machine in front of the installation location. Raise the machine and place it on the floor or on a platform depending on your installation requirements.

2.The water supply line must be plumbed before connecting to the ice maker.

3.Turn on the main water supply and tap. Check for water supply connection leaks. Tighten every connection (including connections at the water inlet).

4.If the electrical outlet for the ice maker is behind the cabinet, plug in the ice maker.

5.Push the ice maker into position.

6.Seal all around the cabinet to the floor with an approved caulking compound.

Operation

Final Check List before Operation

1.Have all packing materials and tape been removed from the interior and exterior of the ice maker?

2.Did you clean the ice storage bin? (See pages 15 - 17.)

3.Have the installation instructions been followed, including connecting the machine to water and electricity?

4.Has the machine been leveled?

5.Is the ice cube machine in a site where the ambient temperature is between 50º F (10º

C)and 100º F (38º C) and the water temperature between 41º F (5º C) and 90º F (32º

C)all year round?

6.Has the water supply pressure been checked to ensure a minimum of 15 psig with a static pressure not to exceed 80 psig?

7.Is there a clearance of at least 2/5_(10 mm) at the rear, 1_(25 mm) at the top and 1/5_ (5 mm) at the sides for proper air circulation?

8.Has the power supply voltage been checked or tested against the nameplate rating? And has proper grounding been installed for the ice cube machine?

9.Is the ice cube machine plugged in?

10.Have you turned on the main water supply and the tap?

11