Friedrich 920-087-04 (3-05) manual Installation Checklist, Section III Chassis Installation

920-087-04 (3-05)

Installation Checklist

Inspect all components and accessories for damage before and after installation.

Remove the cardboard wall sleeve support and grille weatherboard.

Check for proper wall sleeve installation in accordance with the wall sleeve installation instructions.

Check for a subbase kit or other means of structural support which is required for ALL installations projecting more than 8" into room.

Install the recommended Condensate Drain Kits for complete condensate removal.

Ensure that the chassis is installed in a 16" high x 42" wide wall sleeve that is no deeper than 13 3/4". A baffle kit is required if the sleeve exceeds that depth.

Ensure that drapes, bed, bedspread, furniture, etc. DO NOT block either return or discharge air grilles.

Inspect the condenser air inlet and outlet for any obstructions (shrubbery, etc.)

Ensure that 'reset' button is pressed on LCD device (only on cord connected models)

Section III – Chassis Installation

Checktobesurethewallsleeve,extension(ifused),grille,anddrainkitareinstalledproperlybeforechassisinstallation.

1.Removetheweatherboardandcentersupportfromthesleeve (if still in place). Be sure an outdoor grille is attached.

NOTE: To avoid breaking the door or hinge pins, do not apply excessive force when installing

1

Wall sleeve

Weatherboard

2

Pins

Control

Door

Center support

IMPORTANT: Useawall sleeve adapterkit (PXSE)if installing a P-Series chassis in a T-Series sleeve.

Suffocation hazard

Keep bag away from babies and children.

Do NOT use in cribs, beds or playpens. Destroy immediately after opening. This bag is NOT a toy.

Failure to do so can result in personal injury and/or death

Front Panel

3.Remove the two chassis shipping brackets from the ends of the shipping pallet.

3

Compressor

Chassis shipping bracket

Shipping pallet

2.Remove the front cover contained in a protective plastic bag from chassis. Remove the bag and dispose of it properly.

If the control door is not installed, follow these steps:

•From the front of the cover, slide the right control door pin into the hole on the right side of the front cover. Slide the left door pin into the hole on the left side of the front cover opening and snap it into place.

IMPORTANT: When installing a Friedrich P-Series PTAC into an existing sleeve, it is important to ensure that the unit is installed completely. Inspection of the air seal between the condenser air baffles and around the indoor mounting flange is recommended. In some cases additional gaskets or baffling may be required.

14