Wall Sleeve Installation Instructions (PDXWS)
NOTE: Insure that the unit is only installed in a wall structurally adequate to support the unit including the sleeve, chassis and accessories. If the sleeve projects more than 8" into the room, a subbase or other means of support MUST be used. Please read these instructions completely before attempting installation.
Figure 5
Typical Wall Sleeve Installation
|
|
|
|
| . |
| 42¼" |
| min | ||
|
|
|
| ||
|
| cm) |
|
| |
| 3 |
|
|
| |
| . |
|
|
|
|
Lintel to support masonry walls | (107 |
|
|
|
|
|
|
|
|
| |
10" |
|
|
|
|
|
(25.4 cm) |
|
|
|
|
|
max. |
|
|
|
|
|
|
|
|
| 13¾" | |
|
| (34. |
| ||
|
|
| 9 | cm) | |
|
|
|
|
| |
16¼" (41.3 cm)
50" | (127 |
|
Electrical receptacle
| . |
| n |
cm) | mi |
|
Insulation
Electrical receptacle
Wall opening | Wall sleeve |
| Insulation |
Smooth side of screw clip facing into room
Note: All 230/208V units are manufactured with a 60" power cord. The receptacle locations above must be followed to ensure proper connections.
For Deep Wall Installation See Section II
The following instructions apply ONLY to walls less than 13 1/4" in depth.
1.From inside the building, position the wall sleeve in the opening and push it through the wall so it protrudes at least 1/4" on the outside, note Figure 5.
2.Position the wall sleeve with a slight tilt towards the outside to facilitate condensate drainage. It should be level
Electrical shock hazard.
Turn electric power OFF at the fuse box or service panel before making any electrical connections and ensure a proper ground connection is made before connecting line voltage. Failure to do so can result in property damage, personal injury and/or death.
9
