Chassis Installation
STEP 1 | Slide the chassis into the cabinet stopping approximately 3" from full insertion. Stuff the chassis seal gasket (Item #14) one |
| inch deep between the chassis and the cabinet (See Figure P). Begin at either bottom corner and go up the side, across the |
| top, and down the opposite side. Make sure that the gasket is behind the conduit connector (furthest from you). Push the |
| chassis into the shell the remaining distance so that the plastic front shrouds the front edge of the shell. Fasten the junction |
| box mounting foot to the shell with the sheet metal screw. |
| If chassis seal gasket is not installed, the operation of the unit will be negatively affected. Also, the operation noise and |
| outside noise will be amplified. |
NOTE: | Field wiring must be provided to this junction box in accordance with NATIONAL ELECTRIC CODE ARTICLE 501. |
| Field and equipment grounds are to be terminated at the post in the junction box with the green screw provided. Equipment |
| power leads are to be connected with the field supply by means of wire nuts (not provided). Install the gasket and cover |
| plate onto the junction box. |
Figure P
CHASSIS SEAL GASKET
16
