Friedrich US08, US10, US12 manual Remote Control, Power

REMOTE CONTROL

POWER

•To turn the air conditioner ON, push this button.

To turn the air conditioner OFF, push the button again.

•This button takes priority over any other button.

•When you first turn it on, the unit is in cool mode, High fan speed, Temperature setting at 72° F.

•Auto Restart

In the event at a power failure, the unit will run at the previous setting once power returns.

TEMPERATURE SETTING

•Use this button to automatically control the temperature of the room. The temperature can be set within a range of 60° F to 86° F by increments of 1° F.

•The setting appears in the display.

FAN SPEED

•Every time you push this button it advances the setting as follows: (High → Low → Med → High)

TIMER

-SHUT-OFF TIME

•You will usually use shut-off time while you sleep.

•If unit is running, use Timer to set number of hours until shut-off.

•For your sleeping comfort, once Time is set, the Temperature setting will rise 2° F after 30 min, and after another 30 min.

•Push Timer button to advance setting from : 1 Hour → 2 Hours → ..... → 12 Hours maximum.

-START TIME

•If unit is off, use Timer to set number of hours before unit start.

•Push Timer button to advance setting from : 1 Hour → 2 Hours → ..... → 12Hours maximum.

Power

Temp

Fan Speed

Timer Mode

Operating Instrucitons

MODE

-Push this button to shift mode of operation from COOL → MONEY SAVER → FAN.

-COOL :

•Fan runs continually for normal cooling operation.

-MONEY SAVER

•The fan stops when the compressor stops cooling.

Approximately every 3 minutes the fan will turn on and the unit will check the room air temperature to determine if cooling is needed.

-FAN :

•Fan-only operation

7