Operating Instructions
Controls
REMOTE CONTROL SIGNAL
RECEIVER
F1 LOW
F2 MEDTEMPERATURE SETTING
F3 HIGH
• Use this button to automatically control the temperature of the room.
The temperature can be set within a range of 60° F to 86° F by increments of 1° F.
• The setting appears in the display.
POWER
Operating Instructions
TIMER
-
•You will usually use
•If unit is running, use Timer to set number of hours until
•For your sleeping comfort, once Time is set, the Temperature setting will raise 2° F after 30 min., and once again after another 30 min.
•Push Timer button to advance setting from
1Hour → 2 Hours → .... → 12 Hours maximum.
-START TIME
•If unit is off, use Timer to set number of hours before unit starts.
•Push Timer button to advance setting from
1Hour → 2 Hours → ..... → 12 Hours maximum.
•To turn the air conditioner ON, push this button.
To turn the air conditioner OFF, push the button again.
•This button takes priority over any other button.
•When you first turn it on, the unit is in
cool mode, at High fan speed, and set at a temperature setting of 72° F.
FAN SPEED
•Every time you push this button, it advances the setting as follows: {High → Low → Med → High}
MODE
-Push this button to shift mode of operation from COOL → MONEY SAVER → FAN.
-COOL :
•Fan runs continually for normal cooling operation.
-MONEY SAVER:
•The fan stops when the compressor stops cooling. Approximately every 3 minutes the fan will turn on and the unit will check the room air to determine if cooling is needed.
-FAN :
•
AUTO RESTART
When power is restored after an electrical power failure, the unit will begin to run at its previous setting.
6