Care and Cleaning
Burn Hazard
Allow heating element to cool before cleaning the interior. Failure to do so can result in burns.
If hard water causes lime deposit buildup, clean using the following instructions:
1.After dishwasher begins to fill, open door and pour 2 cups of white vinegar into dishwasher.
Do not add dishes or detergent.
2.Run through any full wash cycle.
If it is felt that further interior cleaning is needed, general household spray cleansers are recommended. Follow manufacturer's directions.
Important: The dishwasher motor is permanently lubricated at the factory and does not need to be oiled.
Cleaning the Pump and Spray Arm
Your dishwasher will | Tower | |
flush away all normal | Spray | |
food soils. However, | Arm | |
objects (bones, fruit | ||
| ||
pits, etc.) may collect |
| |
in openings and |
| |
should be removed |
| |
periodically |
| |
to avoid clogging |
| |
drain system. |
|
Heating Element
(caution)
Pump Opening
1.Remove tower base by turning counterclock- wise.
2.Remove locknut and spray arm.
3.Clean out spray arm holes.
4.Clean in and around pump openings.
5.Replace spray arm and securely tighten lock- nut. Spray arm should rotate freely.
6.Replace tower base.
Care of Drain Air Gap
If a drain air gap was installed for your
•Clean float with household cleanser containing vinegar or bleach to dissolve any buildup. Cleaning will prevent float from sticking and stopping a water fill or allowing dishwasher to overflow.
• Pull up firmly to lift
float out. Clean around areas shown in illustration.
• To replace float, push down until float locks into place.
• Float should move up and down freely about one inch when replaced on tube.
9