Installation Instructions
A3. ADAPTING MICROWAVE BLOWER FOR OUTSIDE TOP EXHAUST
5Secure blower unit to microwave with the screw removed in Step 1. Make sure the screw is tight.
6Replace blower plate with the screw removed in Step 1. Make sure the screw is tight.
Back of
Microwave
7Attach the exhaust adaptor to the top of the blower plate by sliding it into the guides of the
blower plate.
Adaptor
Guide
A5. MOUNT THE MICROWAVE OVEN
FOR EASIER INSTALLATION AND PERSONAL SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS MICROWAVE OVEN.
IMPORTANT: Do not grip or use handle during installation.
NOTE: If your cabinet is metal, use the nylon grommet around the power cord hole to prevent cutting of the cord.
NOTE: We recommend using filler blocks if the cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are
not used, case damage may occur from overtightening screws.
Back of
Microwave
Locking Tab
Push in securely until it is in the locking tabs. Take care to assure that the damper hinge is installed so that the damper swings freely.
A4. CHECK FOR PROPER DAMPER OPERATION
Blower Plate | Exhaust Adaptor |
Damper
Back of
Microwave
NOTE: When mounting the microwave oven, thread power cord through hole in bottom of top cabinet. Keep it tight throughout Steps
2Rotate front of oven up against cabinet bottom.
1
Lift microwave, tilt it forward, and hook slots at back bottom edge onto four lower tabs of mounting plate.
•Make sure tape securing damper is removed and damper pivots easily before mounting microwave.
•You will need to make adjustments to assure proper alignment with your house exhaust duct after the microwave is installed.
3Insert a
14