Installation Instructions
A2. USE TOP CABINET TEMPLATE FOR PREPARATION OF TOP CABINET
You need to drill holes for the top support screws, a hole large enough for the power cord to fit through, and a cutout large enough for the exhaust adaptor.
•Read the instructions on the TOP CABINET TEMPLATE.
•Tape it underneath the top cabinet.
•Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling holes in the cabinet bottom.
A3. ADAPTING MICROWAVE BLOWER FOR OUTSIDE TOP EXHAUST
1Place the microwave in its upright position, with the top of the unit facing up.
Blower Plate
Back of
Microwave
Blower Motor
Screw
Remove the screw that holds the blower plate to the microwave. Remove and save the screw holding the blower motor to the microwave.
2Carefully pull out the blower unit. The wires will extend far enough to allow you to adjust the blower unit.
End B
End A
Back of
Microwave
3Roll the blower unit 90° so that fan blade openings are facing out the top of the
microwave.
Before Rotation | After Rotation |
Back of | Back of |
Microwave | Microwave |
4Place the blower unit back into the opening.
AFTER: Fan Blade
Openings Facing Top
Back of
Microwave
CAUTION: Do not pull or stretch the blower unit wiring. Make sure the wires are not pinched, and that they are properly secured.
13
