Frigidaire 318200413 important safety instructions Removable Outer Door Glass Panel some models

Removable Outer Door Glass Panel (some models)

Applicable only to models with an external glass panel not held with a frame. This design allows you to clean the inside face of the exterior door panel as well as the hidden face of the door inner glass. There are two different kinds of glass panel; one with a lower metal trim fixed on the underside of the glass panel and the other one with a lower metal support rail.

To remove the external door glass panel:

1.Pull the door off the range as per instructions under “To Remove and Replace Oven Door” in “Cleaning the Appliance” section and lay the door flat.

2.Using a screwdriver, remove the screws fastening the glass lower metal trim or the glass assembly.

3.Grab both sides of the glass panel and slowly pull it out of the door upper moulding. Lay the glass flat.

Handle the glass panel with care. When dropped on a corner the glass panel may shatter in multiple fragments and you could get hurt.

DO NOT remove the lower metal trim, which is fixed on the underside of the glass panel.

To replace the external door panel:

1.Grab the sides of the glass panel and carefully insert the glass into the door top moulding.

2.Replace the glass lower trim or the glass assembly using the locking screws.

3.Replace the door onto the range as per “To Remove and Replace Oven Door” in “Cleaning the Appliance” section.

To Remove/Replace Storage Drawer

To remove the Drawer:

Push down the left latch and pull up the right latches. Pull drawer out

of range.

ROLLER

RAILS

To Remove/Replace the Storage Drawer with Extendable Glides (some models)

Use the storage drawer for storing cooking utensils. The drawer can be removed to facilitate cleaning under the range. Use care when handling the drawer.

To Remove the Drawer:

1.Pull out the empty drawer until it stops.

2.Push down the left glide latch and pull up the right glide latch.

3.Pull drawer out of the range.

To Replace the Drawer:

1.Slide the drawer rails over the glides.

2.Push the drawer back into the range.

To Remove/Replace the Storage Drawer with Rollers (some models)

To Remove the Drawer:

1.Pull the empty drawer out to the roller guide stop.

2.Tilt the drawer up and pull it out over the rollers.

To Replace the Drawer:

1.Insert the rear end of the drawer into the opening.

2.Fit the drawer end rollers onto the guide rails.

3.Push the drawer in until it stops, then lift to allow the rollers to clear the roller guide stop, and push in.

21