INSTALLATION OF MOUNTING ASSEMBLY
A |
Stopper | G |
|
Rubber Gasket
B |
Sink Flange
H
Lower Mounting Ring
C |
D |
E |
Fiber Gasket
Backup Flange
Mounting Ring
Disposer
Dishwasher Inlet
Hush Cushion® |
F | Snap Ring | NOTE: Hush Cushion included between mounting |
Mount System | ring and lower mounting ring. | |
| ||
READ COMPLETELY BEFORE STARTING
NOTE: Pay close attention to the order of mount assembly parts, as they have been correctly assembled by the factory.
A.Disassemble the mounting assembly, as it has been shipped, by turning the sink flange assembly until the projections align with the notches in the lower mount ring and allow you to pull the sink flange up and out of the remaining lower mount assembly. Note the sequence of these parts as they are stacked to identify each part. Unscrew the 3 mount screws until the mounting ring can be moved to the top of the back up flange. Remove the snap ring with a screw driver.
B.Keep these assembled parts together and set aside. Before you connect the disposer to the mount assembly under the sink. Make sure the lower mounting is in place and the hush cushion is engaged properly to the top of the hopper.
C.Be sure your sink is clean. Pack the underside rim of the sink flange with plumber’s putty. Position the sink flange so it is centered and readable as you look into your sink. Push the sink opening to make a good seal. DO NOT move or rotate the sink flange once seated or the seal may be broken.
D.Take the remaining portion of the mount assembly, as it was set aside and make sure that the rubber gasket is on top of the protector ring. From under the sink, while holding the sink flange firmly with one hand, line up the notches in the mount ring with the projections of the sink flange. Slide the mount assembly up onto the sink flange. Slide the mount assembly up onto the sink flange, past the projections
E.Tighten the 3 mounting screws evenly with a screwdriver (see E). DO NO OVERTIGHTEN! Trim off excess putty.
SINK | A |
| |
| STOPPER* |
| SINK FLANGE** |
PLUMBER’S |
|
PUTTY |
|
| RIDGE |
| FIBER GASKET |
| BACKUP FLANGE |
| MOUNTING RING |
| SNAP RING |
| RUBBER |
| GASKET |
RESET BUTTON
*Batch Feed Stopper looks different than the stopper illustrated.
**Mount Assembly
4
