Frigidaire 560C525P02 manual Electrical Connections, Wiring Disposer Directly to House Current

ELECTRICAL CONNECTIONS

A.Connect disposer to 110-120 Volt, 60Hz AC current only.

B.If plug-in cord is used, use a three prong plub (see A). Ground wire should be attached to the ground screw in the bottom of the end bell (see B).

C.Use a cable clamp strain relief connector where power cord enters the disposer (see C).

Trace lead connected to this blade	RIBBED SIDE	A
and attach that lead to white wire
on disposer.	NOTE: When viewing face of electical
	plug with grounding pin at top,
	the larger left blade is connected to
	the identified wire.

	B	C
	RED RESET BUTTON
	GROUND SCREW	STRAIN
		RELIEF
TO HOUSE	WIRE NUTS
CURRENT OR
POWER CORD
	REMOVE COVER	NUT
	PLATE

Wiring Disposer Directly to House Current

This appliance must be connected to a grounded, metal permanent wiring system or an equipment grounding con- ductor must be run with the circuit conductors and connected to the equipment-grounding terminator or lead on the appliance.

A.If you use BX cable:

1.Install cable connector in hole.

2.Connect white wire to white lead of disposer.

3.Connect black.

4.Connect bare ground.

If BX cable is not used, provide a serpareate ground wire to nearest cold water metal pipe or other suitable ground, using the screw in the bottom of the end bell for the ground wire (see C).

B.If your power supply does not include a ground wire, you must provide one unless metal cable is used. Attach a copper wire securely to disposer ground screw and attach other end of wire to a metal cold water pipe. Use only UL approved ground clamp. If plastic pipe is used in your home, a qualified electrician should install a proper ground.

ATTACHING DISCHARGE ELBOW/ CONNECTING DISPOSER TO MOUNT ASSEMBLY

A. Connect waste elbow to the disposer (see A), proceed

to set B and C then connect bottom of the elbow by

tightening the slip nut (see D).

If you are connecting to a dishwasher, return to section

(B) page 3. If not, make sure all plumbing connections

are tight and in accordance with all plumbing codes and

ordinances. Run water and check for leaks.

B. Hang disposer by aligning 3 mounting tabs with slide-up

RUBBER GASKET

A

B

ramps on mounting ring.

C. Turn mounting ring until all 3 mounting tabs lock over the

rides on the slide-up ramps.

C

D

6