4
BEVERAGE DELIVERY KIT BOX
(9) Faucet and Shank Assembly 1 piec e
(
(10) Plastic Collar 1 piece
11) Shank Nut 1 piece
(12) Faucet Knob 1 piece
(
(13) Regulator 1 piece
14) Keg Coupler 1 piece
(15) Clear Hose (Delivery Line) 1 piece
(16) Red Hose (Gas Line) 1 piece
(17) Rubber Washer (Black) 2 pieces
(
(18) Plastic Hose Clamp (White) 2 pieces
19) CO2 Canister (Empty) 1 piece
(19) CO2
CANISTER
(18) HOSE
CLAMP
(17) RUBBER
WASHER
(13) REGULATOR (14) KEG
COUPLER (15) CLEAR HOSE
(DELIVERY LINE) (16) RED HOSE
(GAS LINE)
(9) FAUCET &
SHANK ASS’Y. (10) PLASTIC
COLLAR (12) FAUCET
KNOB
(1 T 1) SHANK NU
LEVELING
The beverage cooler must have all bottom corners resting
rmly on a solid floor. The floor must be strong enough to
upport a fully loaded beverage cooler. NOTE: It is
fi
s
V
ery
portant for your beverage cooler to be level in order to
nction properly. If the beverage cooler is not leveled during
stallation, the door may be misaligned and not close or seal
roperly, causing cooling, frost, or moisture problems.
Im
fu
in
p
To Level Your Beverage Cooler:
C
warefully tip the unit onto its back. Remove and discard the
ood skid from the bottom using a 3/8” socket wrench. After
iscarding crating screws and wood skid, use a carpenter’s
vel to level the beverage cooler from front to back. Adjust
e plastic leveling feet in front, ½ bubble higher, so that the
oor closes easily when left halfway open.
d
le
th
d
INSTALLATION – GENERAL INSTRUCTIONS
• Choose a place that is near a grounded electrical outlet.
DO NOT use an extension cord or an adapter plug.
• For the most efficient operation, the beverage cooler
should be located where surrounding temperatures will not
drop below 10ºF (-12ºC) or exceed 110ºF (43ºC).
• Allow space around the unit for good air circ ulation. Leave
a 3 inch (75 mm) space on all sides of the beverage cooler
for adequate air circulation.
NOTE: The exterior walls of the beverage cooler may
ecome quite warm as the compressor works to transfer heat
rom the inside. Temperatures as much as 30ºF warmer than
he room temperature can be expected. For this reason it is
articularly important in hotter climates to allow enough
pace for air circulation around your beverage cooler.
b
f
t
p
s