Frigidaire Dual Fuel Range Slide-in Models warranty Removing and Replacing Warm & Serve Drawer

Care & Cleaning

Removing and Replacing Warm & Serve Drawer

To Remove Warm & Serve Drawer:

1. Turn power off before removing the warm & Serve drawer.

2.Open the drawer to the fully opened position.

3.Locate glide lever on each side of drawer, pull up on the left glide lever and push down on the right glide lever (See Figure 1).

4.Pull the drawer away from the range.

To Replace Warm & Serve Drawer:

1.Pull the bearing glides to the front of the chassis glide (See Figure 2).

2.Align the glide on each side of the drawer with the glide slots on the range.

3.Push the drawer into the range until levers “click” (approximately 2”). Pull the drawer open again to seat bearing glides into position. If you do not hear the levers “click” or the bearing glides do not feel seated remove the drawer and repeat steps 1 thru 3. This will minimize possible damage to the bearing glides.

NOTE: The Warm & Serve Drawer will NOT operate while in the “Self-Clean” and “Oven Lockout” modes

Electrical Shock Hazard can occur and result in serious injury or death. Disconnect appliance from electric power before cleaning and servicing the warm & Serve drawer.

	Latch
Left Glide	Pull up latch
	with finger
Latch
Pull down latch	Right Glide
with finger
	Figure 1

Bearing Glide

Figure 2

18