To Level The Freezer:
While unit is lying on its back for wood skid removal, note the location of the four (4) leg levelers installed at each corner. These leg levelers will be used to level the freezer and to adjust the height. Use a carpenter’s level to level the freezer from front to back and side to side.
NOTE
Make sure to allow for the Trim and Leveling Kit if it is to be installed with the unit.
Level Front to Back
& Side to Side
Leveling Instructions For Matching Ta
ll Freezer / Tall Freezer Pair:
•Level door of first unit using all four levelers and slide unit into place. Recheck for levelness and adjust if necessary.
•Measure distance from floor to bottom of door on
first unit. Adjust and level second unit so door height matches.
•Leg Level Adjustments:
•One full turn of all four leg levelers will raise door 5/32”.
LEVELING INSTRUCTIONS
•Slide second unit into place leaving a minimum
gap of 3/16” between units for door swing clearance.
•This last step may require at least one extraction of the second unit to properly align units in a
Leveling Door with Adjustable Hinge
Use the lower hinge adjustment to fine tune the door height and for final cabinet spacing. Use a 7/16” socket or wrench to adjust the screw at the bottom of the lower hinge.
Adjusting Doors For Matching Tall Refrigerator / Tall Freezer Pair
The doors may also be adjusted side to side with the slotted hinge for aligning the doors parallel to each other. Loosen the two bolts with a 3/8” wrench and one screw with a Phillips screwdriver. Shift the doors until parallel, then retighten the screws securely. (See illustration below.)
Lower Hinge Adjustment For Leveling The Doors Of The Matching Tall Refrigerator / Tall Freezer Pair
To level the doors using the adjustable lower hinge (some models):
1.If the freezer door is lower than the freezer door, raise the freezer door by turning the adjustment screw clockwise using a 7/16 inch socket wrench. (See illustration below.)
2.If the freezer door is lower than the freezer door, raise the freezer door by turning the adjustment screw clockwise using a 7/16 inch socket wrench. (See illustration below.)
Slotted Hinge
Adjustment
3/8” Bolts
Screw
Freezer | Refrigerator |
7
