Ice Service
Leveling Bracket
Ice
Container
1” or less
IMPORTANT
Your ice maker is shipped with the wire signal arm in the ON position. To ensure proper function of your ice maker, hook up water supply immediately or turn ice maker OFF by lifting the wire signal arm until it clicks and locks in the UP position.
Check the leveling bracket on the ice maker to ensure the ice maker is level. If the gap between the freezer wall and the ice maker is the same at top and bottom, then ice maker is level. If the ice maker is not level, loosen the screw and slide the bracket to the correct position to make it level. Retighten the screw. You will need a 1/4 inch socket wrench for this task.
CAUTION
•DO NOT place the ice container in dishwasher.
•Wash the ice container in warm water with mild detergent. Rinse well and dry.
•Stop the ice maker when cleaning the freezer and during vacations.
INTERIOR LIGHTING
The mid level and upper level lighting comes on automatically when the door is opened.
To replace the light bulbs:
IMPORTANT
To disconnect power to the unit, unplug the unit or switch the breaker that supplies power to the unit to the off position. Replace the old bulb with a bulb of the same wattage.
1.To replace the light bulb, turn the temperature control to OFF and unplug the electrical cord.
2.Remove the lens from the lamp housing by unsnapping it from the lamp housing using your fingers or a screwdriver. Be careful not to break the locking tabs on the lamp housing.
3.Replace the old bulb with a bulb of the same type and wattage.
4.To replace the lens, snap one side of the lens opening to the tab on the lamp housing. Then carefully attach the other side.
Mid Level Lighting Light Bulb Removal
14 | 14 |