Frymaster MSDU Pump shaft seal fits into the recess of the pump cover, shaft and pull, Replace

Models: MSDU

1 12
Download 12 pages 54.78 Kb
Page 8
Image 8
Pump shaft seal fits into the  recess of the pump cover.

3.Grasp the pump shaft and carefully pull the rotor assembly straight out of the pump housing far enough to expose the vanes. IMPORTANT: The vanes are spring-loaded. Use one hand to hold the vanes while pulling the rotor assembly the rest of the way out of the housing. Carefully release the vanes and discard the worn vanes, springs, and rods.

Pump shaft seal fits into the Step 5 - Replace gasket. recess of the pump cover. Step 3 - Graspshaft and pull

Step 5 - Replace gasket.

Step 1 - Loosen setscrew and remove handle.

 

Step 3 - Grasp

 

shaft and pull

Step 4 - Replace

rotor assembly

out of housing.

vanes, spring,

Step 2 - Remove cover

and rod.

screws and cover.

 

4.Assemble the replacement vanes, spring and rod into the rotor assembly. Compress the vane spring and carefully insert the rotor assembly back into the pump housing.

5.Position the replacement gasket on the pump body, slip the cover over the shaft, and align the pins in the cover with the holes in the pump housing. Reinstall the five screws removed in Step 2 and tighten securely (torque to approximately 60 inch-pounds).

6.Slip the pump handle back onto the shaft and align the screw hole in the handle with the screw hole in the shaft. Tighten the setscrew loosened in Step 1 securely.

6

Page 8
Image 8
Frymaster MSDU Pump shaft seal fits into the recess of the pump cover, Replace gasket - Loosen setscrew and remove handle