Frymaster SCFHD operation manual Installing Casters and Legs, Rear Only Front Only

HIGH EFFICIENCY DECATHLON (HD) SERIES GAS FRYERS

CHAPTER 3: INSTALLATION

3.3Installing Casters and Legs

A.Install casters and/or legs near where the fryer is to be used, as neither is secure for long transit. Decathlon Series gas fryers cannot be curb-mounted and must be equipped with either legs or casters provided.

B.After unpacking, use a pallet or lift jack to raise the unit before installing the casters.

C.Align the caster or leg base holes with the leg support assembly and insert bolt. Install the washers and nut hand tight, and repeat for all four holes in caster/leg base assembly.

D.Tighten the caster/leg against the leg support assembly by using appropriate tools. Ensure that all four bolts are evenly tightened. Tighten the bolts to 50 inch-lbs. (5.65 Nm) torque.

E.For fryer with casters, there are no built-in leveling devices. The floor where the fryers are installed must be level.

Front View Rear Side View

Optional Caster-	Optional Caster-
Rear Only	Front Only

Front Channel or Rear Channel

Front or Rear Leg with

Mounting Plate

Adjust as needed

1/4-20 x 3/4 Hex Bolt

Front Channel or Rear Channel

Leg Support Assembly Washer

1/4-20 Hex Head Locknut

1/4-20 x 3/4 Hex Bolt

Rear Caster—5" Rigid	Front Caster—5" Swivel
	w/Brake

Caster/Leg Installation and Adjustment

WARNING

Dean fryers equipped with legs are for permanent installations. Fryers fitted with legs must be lifted during movement to avoid damage and possible bodily injury. For a moveable or portable installation, Dean optional equipment casters must be used. Questions? Call 1-800-551-8633.

3-2