Contents
24-Hour Service Hotline
MARCH
DANGER
DANGER
Shortening Disposal Unit SDU
Installation, Operation, Service, and Parts Manual
TABLE OF CONTENTS
1.2 Installation, Operating and Service Personnel
INSTALLATION, OPERATION, SERVICE AND PARTS
1.1 Service Information and Parts Ordering
SHORTENING DISPOSAL UNIT SDU 100, 90 50, AND BKSDU
FRYMASTER DOES NOT ASSUME RESPONSIBILITY
FOR DAMAGE OR LOSS INCURRED IN TRANSIT 2. ASSEMBLY AND OPERATION
1.4 Shipping Damage Claim Procedure
1.5 What to Do If Your Equipment Arrives Damaged
Assembly of the unit is a four-step process
2.2 Equipment Assembly
2.3 Equipment Operation
DANGER
4. Carefully withdraw the unit far enough to allow the cover to be closed. Latch the cover in the closed postion. Using the handle, carefully tip the unit back slightly for ease of handling and roll the unit to the disposal site
DO NOT use the pump or discharge piping assembly as a handle DANGER
2.4 Cleaning
DANGER
3.2 Replacing Worn or Damaged O-Rings
3. SERVICE PROCEDURES
3.1 Introduction
3.3 Replacing Worn Pump Vanes and/or Pump Shaft Seal
Step 5 - Replace gasket Step 1 - Loosen setscrew and remove handle
rotor assembly
Pump shaft seal fits into the recess of the pump cover
shaft and pull
4. PARTS LIST
SDU 50, 90, 100 and BKSDU units built April 2010 and later
Component
Kit, Pump Repair includes two vanes, one spring, one rod, one gasket
Crumb Basket
SDU 50, 90, 100 and BKSDU units built before April
NOTE See Page 6 for BKSDU pump assembly components
optional
Component
Housing, 120VAC Receptacle BKSDU only use 823-5060 for 240VAC
Receptacle, 120V 3-wire BKSDU only use 807-4108 for 240VAC
Standard includes Item 2 use 823-4617 for BKSDU
PART #
COMPONENT
Page
TEL 1-318-865-1711 FAX Parts 1-318-688-2200 FAX Tech Support
SERVICE HOTLINE
Frymaster, L.L.C., 8700 Line Avenue, Shreveport, Louisiana
819-5703