LOADING THE BATTERY AND THE xD-Picture Card

4

Close the battery cover.

 

Checking the battery charge

Turn the camera on and check the battery level indicator on the LCD monitor.

◆ How to replace the xD-Picture Card ◆

Push the xD-Picture Card into the slot and then slowly remove your finger. The lock is released and the xD-Picture Card is pushed out.

1

 

 

 

 

 

 

 

 

 

 

 

Lit white

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

2

 

 

 

 

 

 

 

 

 

 

 

Lit white

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

3

 

 

 

 

 

 

 

 

 

 

 

Lit red

 

 

 

 

 

 

 

 

 

 

4

 

 

 

 

 

 

 

 

 

 

 

Blinking red

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

N 10

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

1There is ample battery charge.

2The battery is almost half charged.

3There is insufficient charge left in the battery. The battery will soon run out. Have a new battery ready.

4The battery is depleted. The display will shortly go blank and the camera will stop working. Replace or recharge the battery.

“Z”, “E” or “Ô appears as a small icon on the left-hand side of the LCD monitor.

●! Depending on the camera mode, the transition from “Ô to “V” may occur more quickly.

●! Due to the nature of the battery, the battery level indicator (E, Ã or V) may appear early when the camera is used in cold locations. This is normal. Try warming the battery in your pocket or a similar location before use.

1

Ready Getting

N 10

“V” appears as a large icon in the center of the

LCD monitor.

 

●! Battery with no remaining charge (V blinking red) may cause camera faults such as the camera turning itself off without retracting the lens. Always load a new or fully charged battery.

◆ LCD power save function ◆

When the LCD power save function is active, the LCD monitor darkens to reduce power consumption if the camera is not used for 10 seconds (➡P.79).

Pressing the shutter button down halfway (or pressing any other button) recovers the LCD monitor brightness.

12

13