Check the film tip position, Close the camera back | FujiFilm DL270

10

3. Check the film tip position

Make sure the film tip falls within the Film Tip Mark (green lines in the far end of the film track).

4. Close the camera back

As soon as you close the Camera Back, the Exposure Counter will run though rapidly and the film will prewind itself up to the very end. (If the film is a 24-exposure roll, it will prewind itself in about 20 seconds and the Exposure Counter will stop at the number “24”).

•If the film leader (the length of film protruding from the cartridge) is too short or too long, how- ever, you’ll have to adjust it before dropping the cartridge into the camera.To adjust, pull the film out or wind it in so that the film tip will fall within the camera’s Film Tip Mark (green lines).

•The Film Confirmation Window will show the type and speed of the loaded film and the number of exposures it contains.

Image 10

FujiFilm DL270 owner manual Check the film tip position, Close the camera back

Contents

OWNER,S Manual Contents Special Features Names of Parts Button Liquid Crystal Display Open the battery compartment cover Load the BatteryInsert the battery Check the loaded battery Attach the Strap Open the camera back Load the FilmInsert the film Check the film tip position Close the camera back Mm full-size mode covering area Turn on the powerTaking Pictures Panorama mode Panorama mode covering area Switching back to 35 mm full size mode Zooming to telephoto Zooming to wideangle Hold the camera still Aim the autofocus spot at your subject Press the shutter release about halfway down Take your picture After exposing the last frame END of FilmUnload the exposed film Unloading the film in mid-roll This is the picture you want but Using the Autofocus LockMove the camera slightly While pressing the shutter release about halfway down Word on the camera’s flash exposure modes Selecting the Exposure ModeEffective flash range Taking ordinary pictures Automatic-flash mode in low light Word on red-eye effect Taking non-flash pictures 4. Flash off mode Start the Self-timer Using the SELF-TIMERSet the self-timer Wait 10 seconds Remote control switch Using the Remote Control SwitchTake out the remote control switch Set the camera to remote control Take your remote control picture Effective switch range Carrying the remote control switch Camera FAULTS, Possible CAUSES, and Remedies Faults Possible Causes Remedies Faults Possible Causes Remedies Print FAULTS, Possible CAUSES, and Remedies Camera Care and Cautions Specifications Finder Power Source Self-timerOthers Fujifilm Abroad