For Your Safety

Antennas

Outdoor Antenna Grounding: If an outside antenna or cable system is connected to the video product, be sure the antenna or cable system is grounded so as to provide some protection against voltage surges and built- up static charges. Section 810 of the National Electrical Code, ANSI/NFPA No. 70, provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna discharge unit, connection to grounding electrodes, and requirements for the grounding electrode.

EXAMPLE OF ANTENNA GROUNDING AS PER

NATIONAL ELECTRICAL CODE

Ground Clamp

Antenna Lead

 

in Wire

Use

 

mally follow the operating instructions. Ad-

Cleaning: Unplug this video product from the

 

just only those controls that are covered by

wall outlet before cleaning. Do not use liq-

the operating instructions as an improper

uid cleaners or aerosol cleaners. Use a damp

adjustment of other controls may result in

cloth for cleaning.

damage and will often require extensive work

Object and Liquid Entry: Never push objects

by a qualifi ed technician to restore the video

of any kind into this video product through

product to its normal operation.

openings as they may touch dangerous volt-

When the video product exhibits a distinct

age points or short out parts that could result

change in performance—this indicates a

in a fi re or electric shock. Never spill liquid of

need for service.

any kind on the video product.

Replacement Parts: When replacement parts

 

 

Lightning: For added protection for this video

are required, be sure the service technician

product receiver during a lightning storm, or

has used replacement parts specifi ed by the

when it is left unattended and unused for

manufacturer or have the same characteris-

long periods of time, unplug it from the wall

tics as the original part. Unauthorized sub-

outlet and disconnect the antenna or cable

stitutions may result in fi re, electric shock or

system. This will prevent damage to the vid-

other hazards.

eo product due to lightning and power-line

Safety Check: Upon completion of any service

surges.

or repairs to this video product, ask the ser-

 

 

Service

vice technician to perform safety checks to

Electric Service

Equipment

Ground Clamps

Power Service Grounding

Electrode System (NEC ART

250. PART H)

Antenna Discharge Unit

(NEC SECTION 810-20)

Grounding Conductors

(NEC SECTION 810-21)

Servicing: Do not attempt to service this video

determine that the video product is in proper

product yourself as opening or removing cov-

operating condition.

ers may expose you to dangerous voltage or

 

other hazards. Refer all servicing to qualifi ed

 

service personnel.

 

Damage Requiring Service: Unplug this video product from the wall outlet and refer servicing to qualifi ed service personnel under the following conditions:

Power Lines: An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.

When the power-supply cord or plug is damaged.

If liquid has been spilled, or objects have fallen into the video product.

If the video product has been exposed to rain or water.

If the video product has been dropped or the cabinet has been damaged.

If the video product does not operate nor-

iii