85
Viewing Images
84
hWhen the camera and computer are exchanging
data, the self-timer lamp blinks and the viewfinder
lamp blinks alternately green and orange.
h“DSC” appears on the screen.
hPower Save and Auto Power Off are disabled
during USB connection.
●
!
Before replacing the xD-Picture Card, always disconnect the
camera from the PC using the procedure on P.87.
●
!
Do not disconnect the USB cable when the camera is
communicating with the PC. See P.87 for information on the
disconnection procedure.
●
!
The Windows CD-ROM may also be required during installation. In this event, switch CD-ROMs as directed by the
on-screen instructions.
hFinePixViewer automatically starts up.
✽Screen for Windows 98 SE
Camera Operation
PC Operation
Windows 98/98 SE/Me/2000 Professional
hA removable disk icon appears and you can use your PC to transfer files to and from the
camera.
Windows Macintosh
If the above operations do not occur, you do not have the required software programs or drivers
installed on your PC. Complete the required PC setup procedures. Then reconnect the camera to
your PC.
PC
(USB)socket
DC IN 5V
socket
Socket
Camera
If you are using a Windows PC, the driver settings are specified automatically when installation is
completed. No further action is required.
Always use the prescribed procedure when disconnecting or switching off the camera (➡P.87).
●
!
On Windows XP and Mac OS X, you must specify the automatic launch settings the first time you connect the
camera to your computer.
●
!
Take care to ensure that the special USB cable is connected the correct way around and that the plugs are pushed
fully into the connection sockets.
1Load an xD-Picture Cardcontaining photographed
images into your camera. Plug the AC power
adapter connector into the “DC IN 5V” socket on the
camera and then plug the adapter itself into the
main power outlet.
2Slide the power switch to the side to turn the
camera on.
3Set the “USB MODE” setting in the “SET–UP”
menu to “¶” (➡P.70).
4Slide the Power switch to the side to turn the
camera off.
●
!
It is recommended that you connect the AC Power Adapter
AC-5V. Constant power supply will prevent successful data
transfer from trouble caused by power supply.
5Switch your PC on.
6Use the special USB cable to connect the camera
to your computer.
7Switch the camera on.
Use at DSC mode
01
03