SAFETY INSTRUCTIONS
Before installation and operation, read these instructions carefully and use this product only in the manner described by the manufacturer in the operation manual.
The instructions shown below are used to alert you to potential personal injury and property damage hazards.
There are three hazard classifications based on potentially dangerous situations.
Obey all safety instructions that show these symbols to avoid possible injury, death and property damage.
WARNING: WARNING indicates a potentially hazardous situation which, if not avoided, could
CAUTION:
CAUTION:
result in death or serious injury.
CAUTION indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury.
CAUTION used without the safety alert symbol indicates a potentially hazardous situation which, if not avoided, may result in property damage.
WARNING
1.TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:
a)Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer.
b)Before servicing or cleaning the unit, switch power off at service panel and lock the service disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel.
2.To reduce the risk of fire or electric shock, do not use this product with any
3.TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:
a)Installation work and electrical wiring must be done by a qualified person(s) in accordance with all applicable codes and standards, including
b)Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel burning equipment to prevent back drafting. Follow the heating equipment manufacturer’s guidelines and safety standards such as those published by the National Fire Protection Assoiation (NFPA), and The American Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE), and the local code authorities.
c)When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.
d)Ducted fan must always be vented to outdoors.
4.TO REDUCE THE RISK OF FIRE, USE ONLY METAL DUCTWORK.
5.This unit must be grounded.
6.Install this range hood to the cabinet. Check that the hood is correctly installed, since incorrect installation could result in the range hood becoming detached and falling off.
7.Connect only to an AC120 Volt power source or the range hood could result in fire, electric shock, and damage.
3
