OPERATION
Instructions relating to heating (*) are applicable only to “HEAT & COOL MODEL” (Reverse Cycle).
To Select Mode Operation
1 | Press the START/STOP button (Fig. 5 J). |
The indoor unit’s OPERATION indicator lamp (red) (Fig. 3 5) will light. |
The air conditioner will start operating.
2Press the MASTER CONTROL button (Fig. 5 E) to se- lect the desired mode.
Each time the button is pressed, the mode will change in the following order:
sAUTO | sCOOL | s DRY |
*HEATt | FAN t | |
About three seconds later, the entire display will reappear.
To Set the Thermostat
Press the SET TEMP. buttons (Fig. 5 F).
button: Press to raise the thermostat setting. 
button: Press to lower the thermostat setting.
*●Thermostat setting range: HEAT & COOL MODEL (REVERSE CYCLE)
AUTO | 18 to 30 °C |
Heating | 16 to 30 °C |
Cooling/Dry | 18 to 30 °C |
The thermostat cannot be used to set room temperature during the FAN mode (the temperature will not appear on the remote control unit’s display).
●Thermostat setting range: COOLING MODEL
AUTO | Standard temperature setting ± 2 °C |
Cooling/Dry | 18 to 30 °C |
FAN | 17 to 30 °C |
(During use of FAN mode, if the thermostat is set at 17 °C or lower, the display will show
About three seconds later, the entire display will reappear.
The thermostat setting should be considered a standard value, and may differ somewhat from the actual room temperature.
To Set the Fan Speed
Press the FAN CONTROL button (Fig. 5 I).
Each time the button is pressed, the fan speed changes in the following order:
sAUTO | sHIGH | sMED | s LOW | sQUIET |
Example: When set to COOL
Example: When set to 26 °C
About three seconds later, the entire display will reappear.
6
