Fujitsu C-6591, C-6581 manual Primary Master Submenu of the Main Menu, Auto

M a i n M e n u

Primary Master Submenu of the Main Menu

The Primary Master submenu identifies what ATA devices are installed.

*Note that actual hard drive label shown may vary. Depending on the drive type, information such as cylin- ders, heads and sectors may also be displayed.

PhoenixBIOS Setup Utility

Main

Primary Master [HITACHI_DK23BA-20E-(PM)]		Item Specific Help
Type:	[Auto]	Select ATA/ATAPI drive
Maximum Capacity:	20004MB	installed here.
Multi-Sector Transfers:	[16 Sectors]	[Auto]
LBA Mode Control:	[Enabled]	The BIOS auto-types the
PIO Transfer Mode:	[Fast PIO 4]	drive on boot time.
DMA Transfer Mode:	[Ultra DMA 2]
		Except [Auto]
		You enter parameters of
		the drive.
		[None]
		The drive is disabled.

F1	Help	Select	Item
ESC	Exit	Select	Menu

-/Space	Change	Values
Enter	Select	▲ Sub-Menu

F9 Setup Defaults

F10 Save and Exit

Figure 2. Primary Master Submenu

Table 2: Fields, Options and Defaults for the Primary Master Submenu of the Main Menu

Menu Field	Options		Default	Description
Type:	■	Auto	[Auto]	Selects the ATA/ATAPI device type. Select Auto to have the type
	■	None		automatically identified by the BIOS at POST. If None is selected, all
	■	CD-ROM		of the following Set-up items do not appear. Select CD-ROM if a
	■	Hard Disk		CD-ROM drive is installed at this connection. If Hard Disk is
				selected, you must specify the number of Cylinders, Heads, and
				Sectors for the drive.
Cylinders:	■	A number	–—	This item appears only when Hard Disk is selected. When Hard Disk
		between 0		is selected, you can change the value. This field is changed by
		and 65,535		incrementing (pressing the [Spacebar]) or by typing in the number.
Heads:	■	A number	–—	This item appears only when Hard Disk is selected. When Hard Disk
		between 1		is selected, you can change the value. This field is changed by
		and 16		incrementing (pressing the [Spacebar]) or by typing in the number.
Sectors:	■	A number	–—	This item appears only when Hard Disk is selected. When Hard Disk
		between 0		is selected, you can change the value. This field is changed by
		and 63		incrementing (pressing the [Spacebar]) or by typing in the number.

7