Fujitsu C150-e100-01EN Contents of the Setup Mode, Item, Default, Selectable, parameters, Description

Contents of the Setup Mode

This section describes the contents of the setup mode.

No	Item	Description	Selectable	Default
			parameters
1	Double feed check	Double feed is detected by checking the	Tolerance:	No
		document length one by one.**	No/10/15/20mm
2	IPC pre-setting	Scanner automatically sets the recom-	Document:	No
		mended reading parameters. 5 sets of	No/1/2/3/4/5
		recommended parameters are available.
3	Rest of abrasion	Abrasion counter can be reset.	-	-
	counter
4	Pick start time	The time from the document Insertion to	Time:
	setting	the start of picking is specified. User can	0.2 to 29.8 sec	1.0 sec
		select most comfortable Pick start time for
		the job.
5	Time-out limit setting	The time that the scanner waits for next	Time:
		ducument insertion after last document	27 values from	30 sec
		scanned can be specified.	1 to 1999 sec
6	ADF front offset	Horizontal and vertical offset of the front	Offset:	Offset:
	setting*	side image by ADF is specified.	H:-2 to +3mm	H: 0 mm
			V:-2 to +3mm	V: 0 mm
7	ADF back offset	Horizontal and vertical offset of the back	Offset:	Offset:
	setting*	side image by ADF is specified.	H:-2 to +3mm	H: 0 mm
			V:-2 to +3mm	V: 0 mm
8	FB offset setting*	Horizontal and vertical offset of the FB	Offset:	Offset:
		image is specified.	H:-2 to +3mm	H: 0 mm
			V:-2 to +3mm	V: 0 mm
9	IPC/Memory status	The type of IPC option (IPC-2D or IPC-3D)
	display	and total memory installed are displayed.
10	SCSI ID setting	SCSI ID is selectable.	SCSI ID:
			0/1/2/3/4/5/6/7	5

*This offset means the deference from the value adjusted by automatic offset adjustment.

**The document length on ADF paper chute must be same. If the completely overlapped sheets are fed, the scanner cannot detects the double feed.

6-2