Fujitsu D1241 manual ATX Power Supply Connector 20-pin block Atxpwr

3.HARDWARE SETUP

27)ATX Power Supply Connector (20-pin block ATXPWR)

This connector connects to an ATX power supply. The plug from the power sup- ply will only insert in one orientation because of the different hole sizes. Find the proper orientation and push down firmly making sure that the pins are aligned.

IMPORTANT: Make sure that your ATX power supply can supply at least 10mA on the +5-volt standby lead (+5VSB). You may experience difficulty in power- ing ON your system if your power supply cannot support the load. For Wake- On-LAN support, your ATX power supply must supply at least 720mA +5VSB.

CUR-DLS

+3.3 Volts +3.3 Volts

-12.0 Volts +3.3 Volts

Ground Ground

Power Supply On +5.0 Volts

Ground Ground

Ground +5.0 Volts

Ground Ground

-5.0 Volts Power Good

+5.0 Volts +5V Standby

+5.0 Volts +12.0 Volts

SETUPH/W

Connectors

CUR-DLS ATX Power Connector

28)Two 68-pin Ultra160/Ultra2 SCSI Connectors

This motherboard has two 68-Pin Ultra160/Ultra2 (depending on model) SCSI connectors; one for each of the two channels. Each channel can support a maxi- mum of 15 devices as specified by Ultra160/Ultra2 standards.

1 35

CUR-DLS

SCSI-A

68-Pin Ultra160/

Ultra2-Wide SCSI Connector

34 68

34	1	SCSI-B
68	35

68-Pin Ultra160/Ultra2-Wide SCSI Connector

CUR-DLS Onboard SCSI Connectors

.3

User’s Manual 31