Replacing processor

A26361-D1931-Z120-1-7419, Edition 1 English - 21
Mounting heat sink
Be sure to use heat conducting material between the processor and the heat sink. If a heat
conducting pad (rubber-like foil) is already applied to the heat sink, then use it. Otherwise you must
apply a very thin layer of heat conducting paste.
Heat conducting pads can only be used once. If you remove the heat sink, you mus t clean it and
apply new heat conducting paste before you remount it.
Please note that, depending on the heat sink used, different heat sink mount s are required on the
mainboard.
2
2
2
2
2
1
► Depending on the configuration variant, you
must pull a protective foil off the heat sink or
coat the heat sink with heat conducting
paste before fitting it.
► Secure the heat sink - depending on the
model - with four screws or push it into the
mounts.