Safety Precautions
FOLLOW THESE INSTRUCTIONS AND BE SURE TO HEED ALL WARNINGS AND CAUTIONS DESCRIBED BELOW.
WARNING
Do not touch the power plug with wet hands, since doing so can cause electric shocks.
A damaged AC cable can cause fire or electric shock.
Do not place heavy objects on AC cables, or pull, bend, twist, heat, damage or modify AC cables.
Do not use damaged AC cables or power plugs. Do not install AC cables or power plugs in loose wall sockets.
Do not use cables other than the ones supplied with this product. Use only specified AC cables and connector cables. Failure to use the correct cables might cause electric shock and/or equipment failure.
Use this scanner only at the indicated power voltage and current. Improper power voltage and current might cause fire, electric shock and/or equipment failure.
Do not connect to
Wipe off any dust from metal parts on the power plug or metal fittings with a soft, dry cloth. Accumulated dust might cause fire or electric shock.
Do not install the scanner in locations subject to oil smoke, steam, humidity, and dust. Doing so might cause a fire or electric shock.
If you detect heat coming from the device or detect other problems such as smoke, strange smells or noises, immediately turn off the scanner and then disconnect its power plug.
Make sure that the smoke has stopped and, then contact the store where you bought the scanner or an authorized FUJITSU scanner service provider.
If the scanner is damaged for any reason, turn off the scanner and unplug the power cable before contacting the store where you purchased the scanner.
Do not insert or drop metal objects into the scanner. Do not scan wet documents or documents with paper clips or staples.
Do not splash liquids on or allow the scanner to get wet.
If foreign objects (water, small metal objects, liquids, etc.) get inside the scanner, immediately turn off the scanner and disconnect the power plug from the power outlet, then contact the store where you bought the scanner or the Maintenance Service Center. Pay particular attention to this warning in households where there are small children.
Do not take apart or modify the scanner. The inside of the scanner contains
CAUTION
The following describes important cautions.
Make sure that the scanner is installed on a flat, level surface and that none of its parts extend beyond the surface top, such as a desk or table.
Do not install the scanner on unstable surfaces. Install the scanner on a leveled surface that is free of vibration to prevent it from falling.
Install the scanner on a strong surface that will support the weight of the scanner and other devices.
Firmly insert the power plug as far it can go into the power outlet.
Install the scanner away from strong magnetic fields and other sources of electronic noise. Also, protect the scanner from static electricity as this might cause the scanner to malfunction.
Do not use aerosol sprays to clean the scanner. Aerosol sprays cause dirt and dust to enter the scanner resulting in scanner failure and malfunction.
When the scanner will not be used for a long period, for safety precautions, be sure to disconnect the power plug from the power outlet.
Do not place the scanner in direct sunlight or near a heating apparatus, as excessive heat can build up inside the scanner and cause fire or
Do not block the ventilation ports. Blocking the ventilation ports generates heat inside of scanner, which may result in fire or scanning failure.
Do not place heavy objects on the scanner or use the scanner's surface top to perform other work. Improper installation might cause injuries and equipment failure.
Do not move the scanner with the power and interface cables connected as this can damage the cables, which can later cause fire, electric shock as well as injury.
Before moving the scanner, be sure to disconnect the power plug from the power outlet, and all other data cables.
Make sure that the floor is free of any obstructions.
Avoid touching any scanner mechanism when the scanner is turned on or during scanning since this may cause injuries.
Do not use the device immediately after moving it from a cold place to a warm room. This may cause condensation, which might lead to scanning errors. Let the device dry about one or two hours before you use it.