[fi-6140Z/fi-6240Z]
CAUTION
Only use the supplied AC adapter. Not doing so may cause the scanner to malfunction.
1. Confirm that the computer is turned off.
2. Connect the scanner to the computer with a USB or SCSI cable.
SCSI connection is supported by fi-6140Z/fi-6240Z only.
USB cable and SCSI cable cannot be connected at the same time.
SCSI connector [fi-6140Z/fi-6240Z]
SCSI cable

Installing the Scanner

Install the scanner in the following procedure.1. Place the scanner at its installation site.Carry the scanner by supporting it from the bottom.zfi-6130Z/fi-6140ZOuter dimensions Installation space

380

(14.96)

158

(6.22)

160(6.30)

301

700(27.56)

(11.85)

400

(15.75)

Unit: mm (in.)zfi-6230Z/fi-6240Z

Outer dimensions Installation space

450

(17.72)

229

(9.02)

567(22.32)

3. Attach the ADF paper chute.

Insert the tabs into the slots on the back of the scanner, and tilt the ADF paper chute backwards until it locks in place.

Tab ADF paper chute Side guide

2 1

Connecting the Cables

Connect each cable in the following procedure.SCSI ID switch AC cable [fi-6140Z/fi-6240Z] Power connectorAC adapterUSB connectorUSB cable

400

301(11.85)

800(31.50)

(15.75)

Unit: mm (in.)

2. Unlock the transport lock switch.

For fi-6230Z/6240Z, there is a carrier unit inside the flatbed which is fixed in place to prevent damage during transportation.

Slide the transport lock switch on the front.LockedUnlockedTransport lock switch

5