Fujitsu LT800P warranty Where directory and filename repre

S t y l i s t i c L T 8 0 0 P T a b l e t

Problem	Possible Cause	Possible Solution
IP packet isn’t	Run the PING	Perform the following steps to run the
reaching its	command to check	PING command to check if the IP packet is
destination	the connection	correctly delivered to the destination.
		To run the PING command, the TCP/IP
		protocol must be installed. First you will
		determine your IP address, then you will
		make sure your IP address can respond,
		and then you will make sure other
		computers can be addressed.
		1. Windows 2000:
		Click [Start] -> [Programs] -> [Acces-
		sories] -> [Command Prompt].
		Windows XP:
		Click [Start] -> [All Programs] ->
		[Accessories] -> [Command Prompt].
		2. Type: ipconfig > directory\filename
		where directory and filename repre-
		sent the location at which you want to
		store the IP address.
		3. Click [Enter], then go to the location
		you specified above. The IP address
		for your system will be contained in
		the file.
		4. To check that your IP address is func-
		tioning properly, go back to the DOS
		prompt and type: ping <IP address>,
		then press [Enter]. You will receive
		several replies, followed by the PING
		statistics (similar to below).
		5. To check that your system is communi-
		cating with other systems, go to the
		DOS prompt and type:
		\>ping XXX.XXX.XXX.XXX. (With the
		destination IP address in place of
		XXX.XXX.XXX.XXX).
		(continued on next page)

90