2-1
CHAPTER 2
Preparing to Install the Server
This chapter describes the items you are required to check, the environmental
requirementsfor installation, installation areas, and other relatedmatters. It contains
the following sections:
■Section 2.1, “Safety Precautions” on page 2-1
■Section 2.2, “Before Installing the Server” on page 2-2
■Section 2.3, “Tools and Equipment” on page 2-9

2.1 Safety Precautions

Toprotect both yourself and the equipment, observe the following precautions when
possible:
■Observe the precautions, warnings, and notes on handling shown on the server.
■Use an electrostaticdischarge (ESD) jack or wrist or foot strap when possible.
■Do not block any ventilation holes.
■Do not install the server at a location exposed to direct sunlight or near a device
that may become hot.
■Do not install the server at a location that has a lot of dust or that is exposed to
corrosive gases or air with a high salt concentration.
■Do not install the server at a location exposed to frequent vibrations. Install the
system on a flat and level surface.
■Use grounding wires of class 3 or higher.Sharing any grounding wire will lead to
a malfunction.
■Do not place cables under the equipment or have cables stretched tight. Do not
disconnect a power cord to the server while its power is on.
■Do not place anything on the server or perform any work directly above it.