Important Alert Items
Important Alert Messages
The important alert messages in this manual are as follows:
A hazardous situation could result in minor or moderate personal injury if the user does not perform the procedure correctly. Also, damage to the product or other property, may occur if the user does not perform the procedure correctly.
Task |
| Alert message | Page |
|
|
| |
Installation | Damage |
| |
| Never remove any labels from the drive or deface them in any way. | ||
| High temperature |
| |
| To prevent injury, never touch the drive while it is hot. The DE and LSI | ||
| become hot during operation and remain hot immediately after turning off |
| |
| the power. |
| |
| Damage |
| |
| 1. When dismounting the drive which is mounted on the | ||
| system while power is supplied to it. |
| |
| • | The spindle motor can be stopped by a START/STOP command. It |
|
|
| takes about 15 seconds for the spindle motor to stop completely. |
|
| • | Then, dismount the drive using the drive mounting/dismounting |
|
|
| mechanism, etc. of the system. If the drive is dismounted while the |
|
|
| spindle motor is running, special care is required to avoid excessive |
|
|
| vibration or shock to the drive. It is recommended to stop the |
|
|
| operation once the connector breaks off contact and wait until the |
|
|
| spindle motor stops (about 15 seconds) before dismount the drive. |
|
| • | When storing or transporting the drive, put it in the antistatic bag |
|
|
| (refer to Section 5.1). |
|
|
|
|
|
iii |
