Fujitsu MB91360 manual Getting Started, Softune Workbench Development Introduction

STARTERKIT MB91360

Chapter 3 Getting Started

3 Getting Started

Make sure you have Softune Workbench for FR installed on your PC and the evaluation board is ready to use. For details refer to the Hardware and Software Installation chapters. This chapter uses the available examples to illustrate some features of Softune Workbench.

3.1Softune Workbench Development Introduction

Start Softune Workbench. Select “File – Open Project” to load the first example “LEDdemo1.Prj”. In the project tree on the left side, you can open the “source”-folder which contains the source-files registered to this project. A double-click on one of the files will invoke the built-in editor, which supports syntax-highlighting, tags and various other functions.

Figure 2: Softune Workbench Editor

￿You may customize the editor by a right-click on the editor window.

Whenever you make changes to your source-files, you have to re-compile and link the related files to produce a valid loadmodule (ABS-file). This is done using the MAKE-function. MAKE invokes the assembler, C-compiler and linker for FR whenever necessary (only the changed files will be re-compiled).

If you wish to re-compile the entire project regardless of any changes, you can use the BUILD-function. To check for syntax-errors on a specific source-file, use the COMPILE/ASSEMBLE function.

© Fujitsu Microelectronics Europe GmbH - 11 - UG-910006-13