STARTERKIT MB91360

Chapter 1 Introduction

<Area for extensions (2.54mm grid)

<Standard Euro-format (16x20 cm)

<Built-in monitor debugger (in Flash)

<Software includes Softune Workbench, a set of tools (e.g. flashloader) and example projects.

1.3General Board Usage

The MB91360 Starterkit can be used as stand-alone evaluation board or as a target system for the MB2197-01 In-Circuit-Emulator.

To use the board as stand-alone evaluation board, a pre-programmed flash device (MB91F362 with monitor software) must be present inside the QFP-208 socket. The chip will use the built-in monitor to handle communication with the PC and makes use of the 512k SRAM onboard as program-memory for user’s application. This manual explains how to use the MB91360 Starterkit as a stand-alone evaluation board.

To use the board as target for the In-Circuit-Emulator, unscrew the socket and remove the MB91F362 from the socket. Be careful not to bend any pins of the chip! Using a vacuum chip-handler is highly recommended.

Then mount the emulator probe-cable on top of the QFP-socket. Use the provided screws and make sure the cable has the right orientation. Follow the emulator set-up manual on the CD-ROM for any further steps.

Figure 1: Using the Starterkit as target board for the ICE

© Fujitsu Microelectronics Europe GmbH

- 7 -

UG-910006-13

Page 7
Image 7
Fujitsu MB91360 manual General Board Usage, Using the Starterkit as target board for the ICE