Manuals
/
Fujitsu
/
Computer Equipment
/
Computer Drive
Fujitsu
manual MPC3032AT MPC3043AT MPC3064AT MPC3084AT MPC3096AT MPC3102AT, C141-F029-02EN
Models:
MPC3064AT
MPC3032AT
MPC3043AT
MPC3084AT
MPC3102AT
MPC3096AT
1
1
31
31
Download
31 pages
266 b
1
2
3
4
5
6
7
8
<
>
Troubleshooting
Install
3 Test flowchart
Removal And Replacement Procedure
Maintenance
Self-diagnostics
Perform any removal after the system power is completely
Page 1
Image 1
MPC3032AT
MPC3043AT
MPC3064AT
MPC3084AT
MPC3096AT
MPC3102AT
DISK DRIVES
MAINTENANCE MANUAL
C141-F029-02EN
Page 2
Page 1
Image 1
Page 2
Contents
MPC3032AT MPC3043AT MPC3064AT MPC3084AT MPC3096AT MPC3102AT
DISK DRIVES MAINTENANCE MANUAL
C141-F029-02EN
REVISION RECORD
Revised contents
April
Edition
This page is intentinally left blank
Chapter 2 REMOVAL AND REPLACEMENT PROCEDURE
Chapter 1 MAINTENANCE AND DIAGNOSTIC
PREFACE
The DE is completely sealed. Do not open the DE in the field
Conventions for Alert Messages
C141-F029-01EN
LIABILITY EXCEPTION
This page is intentinally left blank
cable or connector plug when the drive is powered. This
Dont install or remove a PCA or connect or disconnect a
Avoid dangerous detergents when cleaning the disk drive
be unpredictable. Only power the drive with all boards
power ON
Perform any removal after the system power is completely
about 30 s after the power is turned OFF
disconnected. The cable must not be disconnected and the
CHAPTER 2 REMOVAL AND REPLACEMENT PROCEDURE
CONTENTS
This page is intentionally left blank
TABLES
FIGURES
This page is intentinally left blank
1.1 Maintenance 1.2 Operation Confirmation
CHAPTER 1 MAINTENANCE AND DIAGNOSIS
1.3 Troubleshooting Procedure
1.1 Maintenance 1.1.1 Rules for maintenance
5. Keep all vents open opened and unblocked
1.1.2 Maintenance requirements
The DE is completely sealed. Do not open the DE in the field
Page
b. Unpacking
c. Installation
d Never ever remove the DE seal label and screws and the DE cover
d. Packaging
1.1.4 Disk drive revision number
1.1.3 Maintenance levels
Figure 1.1 Disk drive revision number label
Figure 1.2 Display of disk drive revision number
1.1.5 Tools and test equipment
1.1.6 Self-diagnostics
1.1.7 Test
Figure 1.3 Test flowchart
Table 1.2 Disposition for error register contents
Table 1.1 Status register contents
1.2 Operation Confirmation 1.2.1 Operation test
1.3 Troubleshooting Procedure 1.3.1 Troubleshooting procedure
1.2.2 Diagnostic test
1.3.2 Troubleshooting disk drive replaced in field
Table 1.3 System level and field troubleshooting
1.3.3 Troubleshooting at factory
2.1 Spare Parts 2.2 Disk Drive Removal
CHAPTER 2 REMOVAL AND REPLACEMENT PROCEDURE
2.1 Spare Parts
2.2 Disk Drive Removal
Table 2.1 Model and parts numbers
This page is intentinally left blank
I, Place des Etas-Unis, SILIC 310, 94588 Rungis Cedex, FRANCE
Reader Comment Form
FUJITSU LIMITED