Manuals
/
Fujitsu
/
Computer Equipment
/
Computer Drive
Fujitsu
MPC3043AT, MPC3096AT, MPC3102AT, MPC3084AT, MPC3032AT This page is intentinally left blank
Models:
MPC3064AT
MPC3032AT
MPC3043AT
MPC3084AT
MPC3102AT
MPC3096AT
1
3
31
31
Download
31 pages
266 b
1
2
3
4
5
6
7
8
<
>
Troubleshooting
Install
3 Test flowchart
Maintenance
Self-diagnostics
power ON
Page 3
Image 3
This page is intentinally left blank.
Page 2
Page 4
Page 3
Image 3
Page 2
Page 4
Contents
DISK DRIVES MAINTENANCE MANUAL
MPC3032AT MPC3043AT MPC3064AT MPC3084AT MPC3096AT MPC3102AT
C141-F029-02EN
Edition
Revised contents
REVISION RECORD
April
This page is intentinally left blank
Chapter 1 MAINTENANCE AND DIAGNOSTIC
Chapter 2 REMOVAL AND REPLACEMENT PROCEDURE
PREFACE
The DE is completely sealed. Do not open the DE in the field
Conventions for Alert Messages
C141-F029-01EN
LIABILITY EXCEPTION
This page is intentinally left blank
be unpredictable. Only power the drive with all boards
Dont install or remove a PCA or connect or disconnect a
cable or connector plug when the drive is powered. This
Avoid dangerous detergents when cleaning the disk drive
disconnected. The cable must not be disconnected and the
Perform any removal after the system power is completely
power ON
about 30 s after the power is turned OFF
CHAPTER 2 REMOVAL AND REPLACEMENT PROCEDURE
CONTENTS
This page is intentionally left blank
TABLES
FIGURES
This page is intentinally left blank
1.1 Maintenance 1.1.1 Rules for maintenance
CHAPTER 1 MAINTENANCE AND DIAGNOSIS
1.1 Maintenance 1.2 Operation Confirmation
1.3 Troubleshooting Procedure
1.1.2 Maintenance requirements
5. Keep all vents open opened and unblocked
The DE is completely sealed. Do not open the DE in the field
Page
d. Packaging
c. Installation
b. Unpacking
d Never ever remove the DE seal label and screws and the DE cover
1.1.3 Maintenance levels
1.1.4 Disk drive revision number
Figure 1.1 Disk drive revision number label
Figure 1.2 Display of disk drive revision number
1.1.6 Self-diagnostics
1.1.5 Tools and test equipment
1.1.7 Test
Figure 1.3 Test flowchart
Table 1.1 Status register contents
Table 1.2 Disposition for error register contents
1.2 Operation Confirmation 1.2.1 Operation test
1.2.2 Diagnostic test
1.3 Troubleshooting Procedure 1.3.1 Troubleshooting procedure
1.3.2 Troubleshooting disk drive replaced in field
Table 1.3 System level and field troubleshooting
1.3.3 Troubleshooting at factory
CHAPTER 2 REMOVAL AND REPLACEMENT PROCEDURE
2.1 Spare Parts 2.2 Disk Drive Removal
2.1 Spare Parts
2.2 Disk Drive Removal
Table 2.1 Model and parts numbers
This page is intentinally left blank
I, Place des Etas-Unis, SILIC 310, 94588 Rungis Cedex, FRANCE
Reader Comment Form
FUJITSU LIMITED