User response: | Check that the ink cartridge of the imprinter is mounted properly and |
| scan again. |
•Imprinting position is set out of paper. Please check the imprinting position and try again.
Cause: | Printing is not available because the printing part is outside the paper |
| width. |
User response: | Adjust the imprinter so that the printing part is settled within the paper |
| width. |
•A Hardware Alarm is detected in the Imprinter or Endorser option.
Cause:
User response:
Failure on Imprinter or Endorser.
Please check if the Imprinter or the Endorser is installed completely.
If the error occurs after checking the Imprinter or the Endorser, please contact the retail store where the product was purchased or the nearest service center.
•The double feed is detected.
Cause: | The papers are scanned with double feeding. (One paper stuck to |
| another) |
User response: | Remove the papers stopped by double feeding, and reset them. |
•Insufficient memory.
Cause: | Insufficient memory for scanning. The memory available may be |
| insufficient because an application consuming much GDI memory is |
| operating, too many other programs operate at the same time, or there |
| are too many registered device drivers. The user may mistakenly |
| think that adding more memory will solve this problem. However, in |
| most cases, memory shortage is due to insufficient conventional |
| memory (called the main memory within 640 kilobytes). Checking |
| CONFIG.SYS and AUTOEXEC.BAT may be a better solution. |
User response: | Cancel the registration of device drivers that are irrelevant and make |
| sure that only the absolutely necessary programs are operating. Use |
| the memory optimization tool to allocate as much conventional |
| memory as possible. |
98