48
9Click [Finish].
10 Click [Close].
`Click [Advanced] tab, and change the value in [Adaptive Inter Frame Spacing] to
[On] if it is [Off].
11 Restart the system.
For LAN card names displayed in the [Device Manager] after the driver installation, refer to "2.4
Displayed LAN Card Names" (Jpg.49).
Referring to "1.2 Module Version Level" (Jpg.45), check that the drivers updated for all LAN
adapters are correctly updated and that the version is correct.
2.2 Adding a Card
When the system is started right after OS installation or new LAN card installation, the [Found NEW
Hardware] window may appear. The driver will be automatically installed.
However, when other driver than this driver is installed, refer to "2.1 Updating the Driver" (Jpg.47)
to install a driver. For checking the version level, refer to "1.2 Module Version Level" (Jpg.45).
When [Start new hardware search wizard] appears, click [Cancel] to close the window, and refer to
"2.1 Updating the Driver" (Jpg.47) to install a driver.
`[This device cannot start. (Code 10)] may be displayed, but this is not a
problem since the system will operate normally after reboot. After pressing
[Finish], [Help and support center] appears. Click the [x] on the upper right
in the window.
`Do not set a small value in the [Receive Descriptors] in the LAN adapter properties.