Fujitsu S-5582 Primary Master Submenu of the Main Menu, Auto, Enter, Menu Field, Options, Default

L i f e B o o k S S e r i e s B I O S

Primary Master Submenu of the Main Menu

The Primary Master submenu identifies what ATA devices are installed.

Note that actual hard drive label shown may vary. Depending on the drive type, information such as cylin- ders, heads and sectors may also be displayed.

PhoenixBIOS Setup Utility

Main

Primary Master [HITACHI-DK23DA-20-(PM)]		Item Specific Help
Type:	[Auto]	Select ATA/ATAPI drive
Maximum Capacity:	20004MB	installed here.
Multi-Sector Transfers:	[16 Sectors]	[Auto]
LBA Mode Control:	[Enabled]	The BIOS auto-types the
PIO Transfer Mode:	[Fast PIO 4]	drive on boot time.
DMA Transfer Mode:	[Ultra DMA 2]
		Except [Auto]
		You enter parameters of
		the drive.
		[None]
		The drive is disabled.

F1	Help	Select	Item
ESC	Exit	Select	Menu

-/Space	Change	Values
Enter	Select	▲ Sub-Menu

F9 Setup Defaults

F10 Save and Exit

Figure 2. Primary Master Submenu

Table 2: Fields, Options and Defaults for the Primary Master Submenu of the Main Menu

Menu Field	Options		Default	Description
Type:	■	Auto	[Auto]	Selects the ATA/ATAPI device type. Select Auto to have the type
	■	None		automatically identified by the BIOS at POST. If None is selected, all
	■	CD-ROM		of the following Set-up items do not appear. Select CD-ROM if a
	■	SuperDisk		CD-ROM drive is installed at this connection. If User is selected,
	■	Hard Disk		you must specify the number of Cylinders, Heads, and Sectors for
				the drive. Select ATAPI Removable if a removable disk drive is
				installed at this connection.
Cylinders:	■	A number	–—	This item appears only when Auto is selected and the type is
		between 0		identified as hard disk, or User is selected. When User is selected,
		and 65,535		you can change the value. This field is changed by incrementing
				(pressing the [Spacebar]) or by typing in the number.
Heads:	■	A number	–—	This item appears only when Auto is selected and the type is
		between 1		identified as hard disk, or User is selected. When User is selected,
		and 16		you can change the value. This field is changed by incrementing
				(pressing the [Spacebar]) or by typing in the number.

6