Fujitsu Siemens Computers manual Colour monitor 19P2, Ê Ê Ê

Colour monitor 19P2

1 2

1 = Power connector 2 = Data cable

ÊBe sure that the monitor and the computer are switched off.

!

The computer power plug must be pulled!

The data cable (2) is permanently attached to the monitor. It has a 15-pin D-SUB connector for the monitor port of the computer.

ÊConnect the 15-pin connector of the data cable to the (active) monitor port on the computer and secure the plug-in connection by tightening the safety screws.

i

Ê

Ê

Ê

i

If your computer has two monitor ports ("onboard" screen controller and separate graphics card), the monitor port for the separate graphics card is usually active.

Plug the power cable supplied into the power connector of the monitor.

Plug the power cable into the monitor connector at the rear of the computer.

Plug the power connector of the computer into a properly grounded mains outlet.

When you start working with your monitor for the first time you should install the appropriate graphics drivers for your application software. Details of how to do this are provided in the documentation on your graphics card/the associated driver software.

A26361-K713-Z100-1-5E19 English - 9