FUNAI ZV457MG9 Timer Recording, Press Timer Use K / L to select New Program, then press OK

TIMER RECORDING

You can program the unit to record up to 12 programs within a month in advance. Daily or weekly program recordings are also available.

Before recording, make sure

•Set the clock before setting a timer programming.

•Insert a recordable disc with enough recordable space.

SOURCE DTV/TV DISPLAY OPEN/CLOSE

A

.@/: ABC DEF

1 2 3

GHI JKL MNO

4 5 6

PQRS TUV WXYZ

7 8 9

SPACE CLEAR

. 0

DISC MENU SETUP

o

s OK B

TITLERETURN

p

j B i

F h g C

CHANNEL

--+

REC MODE	VCR	DVD	TIMER
REC	HDMI		AUDIO
I
CM SKIP	D.DUBBING TIMER SET RAPID PLAY

Note

•If you have not set the clock yet:

Entry screen for the clock setting will appear instead of the timer programming list at step 1. Continue with the step 4 in “Manual Clock Setting” on page 31 before setting a timer programming.

•Use [s / B] to move the cursor to the left and the right in the entry screen for the timer programming.

•If a basic recording or one-touch timer recording is in progress on one component (e.g., VCR) and the timer recording set for the other component (e.g., DVD) is about to begin, the unit automatically switches to the programmed channel for timer recording 2 minutes before the programmed starting time, and the recording in progress (for VCR) will be canceled UNLESS their recording channels are the same. If their recording channels are the same, the timer recording will start without canceling the recording currently in progress. In this case, the recording of the same channel will be made on both DVD and VCR.

•You cannot make a program whose recording time exceeds 12 hours.

•Cancel the timer-standby mode by pressing

[TIMER SET] before operation for either DVD or VCR. When finished operating, press [TIMER SET] to resume the timer-standby mode.

•In the timer-standby mode, you can turn on the power and use the component (VCR or DVD) which is not currently timer-programmed.

Guide to Timer Programming Display

3	1		2
Timer Programming
JAN/ 2/08 12:00 AM 125.1 SP
SP (1:00)		TUE JAN/01 11:00AM
Date	Start	End	CH	6
JAN/02	12:00AM	1:00AM	DTV125. 1
	New Program
			1/1
4			5

1Title of a timer program (Contains date, time, channel, recording mode of the program)

2 Current date and time

3Recording mode, and length of the recording

4 Timer program list

5 Total number of pages and current page (2 pages maximum)

6 Recording media (“” (DVD) or “” (VCR))

1Press [TIMER].

2Use [K / L] to select “New Program”, then press [OK].

Timer Programming

TUE JAN/01 11:00AM

Date	Start	End	CH
	New Program

•If there are 6 or more programs, use [H / G] to change pages.

3Use [K / L] to enter the date, then press [B].

Date		Start		End
JAN/02	- - : - -			- - : - -
CH		REC To	Mode
DTV125. 1		DVD		SP
			SP	2h00m

JAN/01

p	When pressing [L] at
Daily	the current date, the
p	date will change as
MON-SAT
p	follows.
MON-FRI
p	e.g.) January 1st
SAT

p

FRI

p

pSUN

JAN/31

42 EN