GE JDP36, JDP37 manual Operating, Self-Cleaning Oven, How to Set Oven for Cleaning

How to Set Oven for Cleaning

Quick Reminder:

1.Press the AUTO SELF CLEAN pad.

2.Press the INCREASE or DECREASE pad until the desired Clean Time appears.

1.Follow the directions in the Before a Clean Cycle section.

AUTO SELF	2. After closing the door, press the
	AUTO SELF CLEAN pad.
CLEAN

3.Press the INCREASE or DECREASE pad until the desired Clean Time is displayed.

Clean Time is normally 3 hours. You can change the Clean Time to any time between 2 and 4 hours, depending on the amount of soil in your oven.

The self-clean cycle will automatically begin after “CLEAN” is displayed and the time for the clean cycle is set. The words “ON” and “LOCK” will appear in the display when the door automatically locks. It will not be possible to open the oven door until the temperature drops below the lock temperature and the LOCK light goes off.

4.When the LOCK light is off, open the door.

NOTE:

•You can find out when the clean cycle will be finished by pressing the STOP TIME pad.

•The word “door” will be displayed, the word “LOCK” will flash and oven control will signal if you set the clean cycle and forget to close the oven door.

•A fan may automatically turn on and off to cool internal parts. This is normal, and the fan may continue to run after the oven is turned off.

Operating

How to Delay Start of Cleaning

Quick Reminder:

1.Press the AUTO SELF CLEAN pad.

2.Press the INCREASE or DECREASE pad until the desired Clean Time appears.

3.Press the STOP TIME pad.

4.Press the INCREASE or DECREASE pad until the desired Stop Time appears in the display.

Delay Start is setting the oven timer to start the clean cycle automatically at a later time than the present time of day.

NOTE: Before beginning, make sure the oven clock shows the correct time of day.

1.Follow the directions in the Before a Clean Cycle section.

AUTO SELF	2. After closing the door, press the
	AUTO SELF CLEAN pad.
CLEAN

3.Press the INCREASE or DECREASE pad to enter the Clean Time.

The earliest Stop Time will be the Clean Time selected plus the time of day. For example: If the Clean Time is three hours and the time of day is 6:00, the Stop Time that appears in the display will be 9:00.

5.Press the INCREASE pad to change the Stop Time to a later time of day if desired. For example: If you set Stop Time at 11:00, oven will start clean cycle at 8:00 and end at 11:00. The door latches automatically.

The self-clean cycle will automatically begin after “CLEAN” is displayed and the time for clean cycle is set. The words “ON” and “LOCK” will appear in the display when the door automatically locks. It will not be possible to open the oven door until the temperature drops below the lock temperature and the LOCK light goes off.

6.When the LOCK light is off, open the door.

NOTE:

•During a delayed self-clean operation you can find out when the oven is set to turn on by pressing and holding the AUTO SELF CLEAN pad for 3 seconds.

•A fan may automatically turn on and off to cool internal parts. This is normal, and the fan may continue to run after the oven is turned off.

(continued next page)

the Self-Cleaning Oven

4.Press the STOP TIME pad. “STOP

STOP	TIME” and the earliest Stop Time you can
TIME	set will appear in the display.	23